Nissan Sentra B18 (2020-2025) Service Manual: Fuel Pump
Component Inspection
Component Inspection
-
CHECK FUEL PUMP
-
Turn ignition switch OFF.
-
Disconnect “fuel level sensor unit and fuel pump” harness connector.
-
Check the resistance between “fuel level sensor unit and fuel pump” terminals as follows.
Fuel level sensor unit and fuel pump
Condition
Resistance
Terminal
7
8
Temperature
25°C (77°F)
0.2 – 5.0 Ω
Is the inspection result normal?
YES >>INSPECTION END
NO >>Replace “fuel level sensor unit and fuel pump”. Refer to Removal and Installation.
-
Other materials:
Primary Pressure Solenoid Valve Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK HARNESS CONNECTOR
Ignition switch OFF.
Check the mating condition of TCM
harness connector and CVT unit harness
connector.
Is the inspect ...
B24d4-08 A/c Control Comm
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...
Consult Checking System
Description
Description
Note:
This vehicle is diagnosed using the CONSULT-III
plus.
When CONSULT is connected with a data link connector equipped on the
Nissan Sentra vehicle side, it will
communicate with the control unit equipped in the vehicle and then
...