Toyota Camry Owner's Manual (2023): Engine coolant
The coolant level is satisfactory if it is between the "F" and "L" lines on the reservoir when the engine is cold.
- Reservoir cap
- "F" line
- "L" line
If the level is on or below the "L" line, add coolant up to the "F" line.
â– Coolant selection
Only use "Toyota Super Long Life Coolant" or a similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology.
U.S.A.:
"Toyota Super Long Life Coolant" is a mixture of 50% coolant and 50% deionized
water. (Minimum temperature: -31
F
[-35
C] )
Canada:
"Toyota Super Long Life Coolant" is a mixture of 55% coolant and 45% deionized
water. (Minimum temperature: -44
F
[-42
C] )
For more details about engine coolant, contact your Toyota dealer.
â– If the coolant level drops within a short time of replenishing
Visually check the radiator, hoses, engine coolant reservoir caps, drain cock and water pump.
If you cannot find a leak, have your Toyota dealer test the cap and check for leaks in the cooling system.
WARNING
â– When the engine is hot
Do not remove the engine coolant reservoir cap or the radiator cap.
The cooling system may be under pressure and may spray hot coolant if the cap is removed, causing serious injuries, such as burns.
NOTICE
â– When adding coolant
Coolant is neither plain water nor straight antifreeze. The correct mixture of water and antifreeze must be used to provide proper lubrication, corrosion protection and cooling. Be sure to read the antifreeze or coolant label.
â– If you spill coolant
Be sure to wash it off with water to prevent it from damaging parts or paint.
Radiator and condenser
Check the radiator and condenser and clear away any foreign objects.
If either of the above parts is extremely dirty or you are not sure of their condition, have your vehicle inspected by your Toyota dealer.
WARNING
â– When the engine is hot
Do not touch the radiator or condenser as they may be hot and cause serious injuries, such as burns.
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
â– Checking the engine oil
1. Park the vehicle on level ground. After warming up the engine
and turni ...
Brake fluid
â– Checking fluid level
The brake fluid level should be
between the "MAX" and "MIN"
lines on the tank.
"MAX"
"MIN"
â– Adding fluid
Make sure to check the fluid type and prepare the ne ...
Other materials:
Rear seat belt
Exploded View - Seat Belt Retractor
Seat belt retractor (RH)
Seat belt retractor (center)
Seat belt retractor (LH)
Front
Removal and Installation - Seat Belt Retractor
REMOVAL
Remove the rear parcel shelf finisher. Refer to INT-33, "Removal and
Installation".
Re ...
System
VDC/TCS/ABS
VDC/TCS/ABS : System Diagram
VDC/TCS/ABS : System Description
The system switches fluid pressure of each brake caliper and
each wheel cylinder to increase, to hold, or to
decrease according to signals from control unit in ABS actuator and electric
unit (control unit) ...
Sudden start restraint control (Drive-Start Control [DSC] )
When the following unusual operation is performed with the accelerator
pedal depressed, the engine output may be restrained.
When the shift lever is shifted to R*.
When the shift lever is shifted from P or R to forward drive shift
position such as D*.
When the system operates, a message ...
