Nissan Sentra manuals

Toyota Camry Owner's Manual (2023): Drive information

■ Trip (after start)

  1. Average fuel economy*
    Displays the average fuel consumption since engine start.
  2. Average vehicle speed
    Displays the average vehicle speed since engine start.
  3. Elapsed time
    Displays the time elapsed since engine start.

Multi-information display (4.2-inch display)

*: Use the displayed fuel consumption as a reference only.

■ Total (after reset)

  1. Current fuel consumption
    Displays the instantaneous current fuel consumption.
  2. Average fuel economy*1, 2
    Displays the average fuel consumption since the display was reset.
  3. Average vehicle speed/ Elapsed time*1
    Displays the average vehicle speed since reset or elapsed time since reset, as selected in .

Multi-information display (4.2-inch display)

*1: Pressing and holding will reset the average fuel consumption and average vehicle speed/elapsed time.
*2: Use the displayed fuel consumption as a reference only.

■ Tank (after refuel)

  1. Driving range*1, 2
    Displays the driving range with remaining fuel.
  2. Average fuel economy*1, 3
    Displays the average fuel consumption since the vehicle was refueled.

Multi-information display (4.2-inch display)

*1: When only a small amount of fuel is added to the tank, the display may not be updated.
When refueling, turn the engine switch off. If the vehicle is refueled without turning the engine switch off, the display may not be updated.
*2: This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
*3: Use the displayed fuel consumption as a reference only.

■ Speedometer

Displays the vehicle speed.

■ Blank (No items)

Displays no drive information contents.

Summary of functions
The multi-information display presents the driver with a variety of driving- related data, such as the current outside temperature. The multiinformation display can also be used to change the displa ...

Settings display
◆ Changing settings Use the meter control switches on the steering wheel to change settings. 1. Press or to select . 2. Operate the switches to select a desired item. 3. Change the setting ...

Other materials:

Filament
Inspection and Repair Inspection When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is burned out ...

Display - Intuitive parking assist
When the sensors detect an object, the following displays inform the driver of the position and distance to the object. Front corner sensor operation Front center sensor operation Rear corner sensor operation Rear center sensor operation Select to mute the buzzer sounds. ■Mutin ...

P0447 EVAP Canister vent control valve
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0447 VENT CONTROL VALVE (Evaporative emission system vent control circuit open) An improper voltage signal is sent to ECM throug ...

© 2014-2023 Copyright www.nisentra.com