Nissan Sentra Owners Manual: Door locks/unlocks precaution

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / NISSAN Intelligent Key® (if so equipped) / Door locks/unlocks precaution

Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have difficulty recognizing that the Intelligent Key is outside the vehicle.
After locking with the door handle request switch, verify the doors are securely locked by testing them.
To prevent the Intelligent Key from being left inside the vehicle, make sure you carry the Intelligent Key with you and then lock the doors.
Do not pull the door handle before pushing the door handle request switch. The door will be unlocked but will not open. Release the door handle once and pull it again to open the door.

Operating range

The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1. When the Intelligent Key battery is discharged or str ...

NISSAN Intelligent Key® Operation

You can lock or unlock the doors without taking the Intelligent Key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors by pushing the doo ...

Other materials:

Rear suspension beam
Exploded View Rear suspension beam Rear suspension arm bracket Front Removal and Installation NOTE: When removing components such as hoses, tubes, lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL Remove the rear wheels and tires using power tool. Ref ...

C1143 Steering angle sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1143 ST ANG SEN CIRCUIT When a malfunction is detected in steering angle sensor. Harness or connector Steering angle sensor ABS actuator and electric u ...

Filament
Inspection and Repair Inspection When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is burned out ...