Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Diagnosis and Repair Work Flow

Nissan Sentra B18 (2020-2025) Service Manual / Cruise Control & Driver Assistance / Drive Mode System :: Eco Mode (cvt) / Basic Inspection / Diagnosis and Repair Work Flow

Work Flow

Work Flow

OVERALL SEQUENCE

DETAILED FLOW

  1. GET INFORMATION FOR SYMPTOM

    Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the “Diagnostic Work Sheet”. (Refer to Diagnostic Work Sheet (ECM) or Diagnostic Work Sheet (TCM).

    >>

    GO TO 2.

  2. CHECK DTC

    CONSULT

    1. Check DTC of “All DTC Reading”.

    2. Perform the following procedure if DTC is displayed.

      • Record DTC and freeze frame data. (Or, write it down.)

    3. Check related service bulletins for information.

    Is any DTCs detected?

    YES >>

    Perform the trouble diagnosis for DTC indicated.

    NO >>

    GO TO 3.

  3. CONFIRM THE SYMPTOM

    Try to confirm the symptom described by the customer.

    Also study the normal operation related to the system. Refer to System Description.

    >>

    GO TO 4.

  4. CHECK ECO MODE SWITCH CIRCUIT

    Check ECO mode switch circuit. Refer to Diagnosis Procedure.

    Is inspection result normal?

    YES >>

    GO TO 5.

    NO >>

    Repair or replace malfunctioning component.

  5. CHECK ECO MODE SWITCH AND METER INDICATION

    1. Ignition switch OFF and wait at least 10 seconds.

    2. Ignition switch ON.

    3. Check that STANDARD is displayed on the information display screen of the combination meter.

    4. Check that the view of information display changes as ECO mode indicator signal (OFF).

    5. Check that the view of information display changes as ECO mode indicator signal (ON).

    Is the inspection result normal?

    YES >>

    Inspection End.

    NO >>

    Check intermittent incident. Refer to Intermittent Incident.

Basic Inspection
...

Dtc/circuit Diagnosis
...

Other materials:

List of Ecu Reference
List of ECU Reference ECU Reference ECM Values On The Diagnosis Tool Physical Values ...

Brake Fluid Level and Leaks
Inspection Inspection BRAKE FLUID LEVEL Make sure that the brake fluid level in the master cylinder reservoir tank is between the MAX and MIN lines. Visually check around the master cylinder reservoir tank for brake fluid leaks. ...

Squeak and rattle trouble diagnoses
Work Flow Customer interview Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the diagnostic worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to rf-37, "d ...

© 2014-2026 Copyright www.nisentra.com