S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: Brake Pedal

Exploded View

Exploded View

1.

Brake pedal assembly

2.

Clevis pin

3.

Brake pedal pad

4.

Clip

5.

Stop lamp switch

6.

Brake pedal position switch

7.

Snap pin

        
Note:

The CVT brake pedal assembly is shown. The 6MT brake pedal assembly is similar.

Removal and Installation

Removal and Installation

REMOVAL

Remove the bolts and separate the accelerator pedal assembly from the brake pedal assembly. Refer to Exploded View. Note:

Leave the harness connector on the accelerator pedal assembly.

Remove the snap pin and the clevis pin from the brake pedal assembly and the brake booster push rod. Refer to Exploded View.

Remove the nut from the bottom of the brake pedal assembly.

Remove the nuts and the brake pedal assembly from the brake booster. Refer to Exploded View.

CAUTION:

Support the brake booster and master cylinder assembly to avoid dropping or contacting other parts.

Remove the stop lamp switch, if necessary.

Remove the brake pedal position switch, if necessary.

INSPECTION AFTER REMOVAL

  • Check the following items and replace the brake pedal if necessary.

    • Check the rocker arm (A) for damage and cracks.

    • Check the brake pedal rivet (B) for deformation.

INSTALLATION

Installation is in the reverse order of removal.

  • Apply multi-purpose grease to the clevis pin.

  • Inspect the brake pedal height after installing the brake pedal to the Nissan Sentra vehicle. Refer to Inspection.

CAUTION:

Replace the brake pedal if it has been dropped or sustained an impact.

    Brake Piping. Hydraulic Layout
    Hydraulic Layout Hydraulic Layout DRUM BRAKE 1. Front disc brake 2. Master cylinder 3. Brake booster 4. Rear drum brake 5. ABS actuator and electric unit (control unit) A. Brake...

    Other materials:

    Decel G Sensor Calibration
    Description Description TCM stores calibration data (inherent characteristic value) of decel G sensor to provide accurate control. Therefore, it is required to perform calibration of decel G sensor after the following work is performed. Removing/ installing ABS actuator ...

    Component Parts
    Meter System Component Parts Location Component Parts Location MODELS WITH CVT A. View of engine assembly removed ...

    P059f Active Grille Shutter
    Dtc Description DTC Description DTC DETECTION LOGIC Active grille shutter normally stops within zone which is defined by zone (90°±20°). If the active grille shutter stops within zone stuck error is detected, and if the active grille shutter stops at position beyond zon ...