Toyota Camry Owner's Manual (2023): Approach warning (vehicle-to-vehicle distance control mode) - Dynamic radar cruise control with full-speed range
When your vehicle is too close to a vehicle ahead, and sufficient automatic deceleration via the cruise control is not possible, the display will flash and the buzzer will sound to alert the driver. An example of this would be if another driver cuts in front of you while you are following a vehicle.
Depress the brake pedal to ensure an appropriate vehicle-to-vehicle distance.
â– Warnings may not occur when
In the following instances, warnings may not occur even when the vehicle-to-vehicle distance is small.
- When the speed of the preceding vehicle matches or exceeds your vehicle speed
- When the preceding vehicle is traveling at an extremely slow speed
- Immediately after the cruise control speed was set
- When depressing the accelerator pedal
Curve speed reduction function
While driving in vehicle-to-vehicle distance control mode, this function will reduce the vehicle speed, if it is determined to be necessary.
â– Function operation
When the steering wheel begins to be turned, the vehicle speed will begin being reduced. When the steering wheel is returned to the center position, the vehicle speed reduction will end.
Depending on the situation, the vehicle speed will then return to the vehicle-to-vehicle distance control mode set speed.
In situations where vehicle-to-vehicle distance control needs to operate, such as when a preceding vehicle cuts in front of your vehicle, the curve speed reduction function will be canceled.
â– Operation display
Displayed when the vehicle speed is being reduced.
When the vehicle speed reduction ends, the display will disappear.
â– Changing the settings of the curve speed reduction function
The curve speed reduction function can be enabled/disabled and
the vehicle speed reduction strength can be adjusted on
(4.2-
inch display) or 
(7-inch display)
of the multi-information
display.
The setting will change each time 
of the meter control switch is
pressed.
Adjusting the set speed - Dynamic radar cruise
control with full-speed
range
Adjusting the set speed by the switch
To change the set speed, press the "+ RES" or "- SET" switch until the
desired set speed is displayed.
Increases the speed
(Except when the vehicle h ...
Selecting constant speed control mode - Dynamic radar cruise
control with full-speed
range
When constant speed control mode is selected, your vehicle will maintain
a set speed without controlling the vehicle-to-vehicle distance.
Select this mode only when vehicle-to-vehicle distance con ...
Other materials:
Intermittent Incident
DESCRIPTION
Sometimes the symptom is not present when the vehicle is brought in for
service. If possible, re-create the
conditions present at the time of the incident. Doing so may help avoid a No
Trouble Found Diagnosis. The fol-
lowing section illustrates ways to simulate the conditions/env ...
B1430, B1432 Seat belt pre-tensioner LH
Description
DTC B1430, B1432 SEAT BELT PRE-TENSIONER LH
The seat belt pre-tensioner LH is wired to the air bag diagnosis sensor unit.
The air bag diagnosis sensor unit
will monitor for opens and shorts in detected lines to the seat belt pre-tensioner
LH.
PART LOCATION
Refer to SRC-5, " ...
Ecu diagnosis information
ECM
Reference Value
VALUES ON THE DIAGNOSIS TOOL
NOTE:
The following table includes information (items) inapplicable to this
vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
Numerical values in the following table are reference values.
Thes ...
