Nissan Sentra manuals

Nissan Sentra Service Manual: Rear power window motor

Removal and Installation

REMOVAL

  1. Remove the rear door glass regulator (1). Refer to GW-21, "Removal and Installation"
  2. Remove the screws and the rear power window motor (2).

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Rear regulator
Exploded View Rear door panel Rear door glass regulator motor Rear door glass regulator Rear door glass Rear door glass rubber run Removal and Installation NOTE: RH rear door pane ...

Side window glass
Components Side window glass Spacer Headlining Rear body pillar Rear pillar finisher Rear door weatherstrip Primer area Adhesive 7 mm (0.3 in) 12 mm (0.5 in) Removal a ...

Other materials:

Parking brake shoe
Adjustment - Drum Brake If equipped with drum brakes, refer to PB-11, "Inspection and Adjustment". Adjustment - Disc Brake Adjust parking brake lever stroke. Refer to PB-4, "Inspection and Adjustment". Perform parking brake break-in (drag on) operation by d ...

B0010, B0011 Passenger airbag module
Description DTC B0010, B0011 PASSENGER AIR BAG MODULE The passenger air bag module is dual stage and is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the passenger air bag module. PART LOCATION Refer to S ...

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

В© 2014-2026 Copyright www.nisentra.com