Nissan Sentra Service Manual: Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Commercial Service Tools
Precaution for Harness Repair
Solder the repair part, and wrap it with tape. [Twisted wire
fray
must be 110 mm (4.33 in) or less.]
Do not bypass the repair point with wire. (If it is
bypassed, the turnou ...
Other materials:
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition
Maintain test condition until A/C system becomes stable. (Approximately
10 minutes)
Check t ...
Drive belt
Automatic tensioner
Generator
Water pump
Air conditioner compressor
Crankshaft pully
WARNINGBe sure the ignition switch is in the OFF
or
LOCK position before servicing drive belt.
The engine could rotate unexpectedly.
Visually inspect the belt for signs of ...
Eps warning lamp does not turn on
Description
EPS warning lamp does not turn ON when turning ignition switch
ON from OFF. (Check the illumination of the
EPS warning lamp.)
Diagnosis Procedure
1.CHECK EPS WARNING LAMP
Perform the trouble diagnosis of EPS warning lamp. Refer to
STC-31, "Diagnosis Procedure".
Is ...
