Nissan Sentra manuals

Nissan Sentra Service Manual: Preparation

Special Service Tools

The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

*: The O-ring as a unit part is set as a SST.


*: The O-ring as a unit part is set as a SST.

Commercial Service Tools


System description


Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE- ...

System description
Component parts CVT CONTROL SYSTEM CVT CONTROL SYSTEM : Component Parts Location No. Component Function 1 ECM Mainly transmits the following signal to TCM via CAN ...

Other materials:

Interior room lamp control circuit
Description Controls each interior room lamp (ground side) by pwm signal. Note: Pwm signal control period is approximately 250 hz (in the gradual brightening/dimming). Component function check Caution: Before performing the diagnosis, check that the following are normal. Interior room l ...

P0441 EVAP Control system
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0441 is displayed with other DTC such as P2122, P2123, P2127, P2128 or P2138, first perform trouble diagnosis for other DTC. In this evaporative emission (EVAP) control system, purge flow occurs during non-closed throttle conditions. Purge volu ...

Precaution
Precautions for Trouble Diagnosis Caution: Follow the instructions listed below. Failure to do this may cause damage to parts: Never apply 7.0 V or more to the measurement terminal. Use a tester with open terminal voltage of 7.0 V or less. Turn the ignition switch off and disconnect the ...

© 2014-2026 Copyright www.nisentra.com