Nissan Sentra Service Manual: Periodic maintenance

Symptom diagnosis

Noise, vibration and harshness(NVH) troubleshooting NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicabl ...

Front wheel hub and knuckle

Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TY ...

Other materials:

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,500 rpm under no load (for example, the selector lever position is neutral and engine speed is over 2,500 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

Front drive shaft
6M/T 6M/T : Exploded View (LH) Front drive shaft Nut retainer Cotter pin Molykote M77 Front 6M/T : Removal and Installation (LH) NOTE: When removing components such as hoses, tubes, lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL Remove the ...

1144 Incomplete steering angle sensor adjustment
DTC Logic Dtc detection logic Dtc Display item Malfunction detected condition Possible causes C1144 St ang sen signal When neutral position adjustment of steering angle sensor is not complete. Harness or connector Steering angle sensor Abs actu ...