Description
Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up.
Component function check
1.Check door mirror defogger rh
Check that the heating wire of door mirror defogger rh is heated when turning the rear window defogger switch on.
Is the inspection result normal? Yes >> door mirror defogger rh is ok.
No >> refer to def-37, "diagnosis procedure".
Diagnosis procedure
Regarding Wiring Diagram information, refer to DEF-20, "Wiring Diagram".
1. Check power supply circuit
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace harness.
2. Check ground circuit
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness.
3. Check passenger side door mirror defogger
Check door mirror defogger rh.
Refer to def-38, "component inspection".
Is the inspection result normal? Yes >> go to 4.
No >> replace door mirror rh. Refer to mir-18, "door mirror assembly : removal and installation".
4. Check intermittent incident
Check intermittent incident.
Refer to gi-39, "intermittent incident".
Is the inspection result normal? Yes >> check the following.
No >> repair or replace the malfunctioning parts.
Component inspection
1. Check door mirror defogger rh
Is the inspection result normal? YES >> Inspection End.
NO >> Replace door mirror RH. Refer to MIR-18, "DOOR MIRROR ASSEMBLY : Removal and Installation".
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT
BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injur ...
Continuously Variable Transmission (CVT) (if so equipped)
WARNING
Do not depress the accelerator pedal
while shifting from P (Park) or N (Neutral)
to R (Reverse), D (Drive) or L (Low).
Always depress the brake pedal until
shifting is completed. Failure to do so
could cause you to lose control and
have an accident.
Col ...
Ecm branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ecm for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
YES > ...