Nissan Sentra Service Manual: Component parts
Meter system
METER SYSTEM : Component Parts Location
- ABS actuator and electric unit (control unit)
- Combination meter
- CVT shift selector (with CVT) (O/D OFF switch)
- Air bag diagnosis sensor unit (view with center console assembly removed)
- Parking brake switch (view with center console removed)
- Fuel level sensor unit and fuel pump (view with fuel pump inspection cover removed)
- Seat belt buckle switch LH (RH similar)
- Front door switch LH (RH similar)
- BCM (view with instrument panel removed)
- Power steering control module (view with steering column assembly removed)
- Brake fluid level switch
- TCM (with CVT)
- ECM
- Engine oil pressure sensor
- Illumination control switch
- ECO mode switch (with CVT)
- Sport mode switch (with CVT)
- Ambient sensor
- A/C auto amp.
(with auto A/C) (view with A/C switch assembly removed)
- Washer fluid level switch (view with front fascia removed)
- Steering switch
METER SYSTEM : Component Description
System
Meter system
Meter system : system diagram
Meter system : system description
COMBINATION METER
The combination meter receives signals from switches, sensors and modules to
control the foll ...
Other materials:
Evap leak check
Inspection
CAUTION:
Do not use compressed air or a high pressure pump.
Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP
system.
NOTE:
Do not start engine.
Improper installation of EVAP service port adapter [commercial
service tool: (J-41413-OBD)] to the EVAP
...
Turn signal switch
Turn signal
Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signal cancels automatically.
Lane change signal
To signal a lane change, move the lever up or
down to the point where the indicator light
begins to flash, but the lever ...
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...